[Upgraded Pump] LCD Automatic Drip Irrigation Kit for 15 Plants, DIY Plant Self Watering System Device Digital Programmable Water Timer, Waterer for Indoor House Plant Vacation Watering

Product Description

Automtic Drip Irrigation Kit for Indoor Plants

Don't worry anymore!! When you are outside, the automatic watering system can take care of your plants, so you can rest assured to work or travel Automatic watering device is the best solution for you to take care of plants when you are out on holiday and work Using an automatic waterer to water the plants regularly every day can effectively extend the life of the plants and make the plants grow well and more lush

How the watering unit helps for caring your plants?

Automatic watering and easy customization on watering cycle Digital panel and simple three button for easy setting Included all-in-one accessories, easy 4 steps set up Two Types of Power; Supports AA battery/direct USB charge Saving 70% less water than traditional spray Time cycle settings are stored in internal memory automatically Your Plants are never be neglected!

Updated Fully Display & Programmable Settings

Watering Time: How long for watering plants ( 05-55 sec, 01-59 min ) Watering Interval: How often/ frequency for watering plants ( 01-23 hr, 01-30 d ) Delay: The count backwards time user want to water plant for the first time ( 0 hr-30 d )

Long press the up or down button to switch unit

Please peel off the protective film on the panel for better experience

Watering System Setting

1. Design your loop

We recommend you to draw a design map of your loop, which indicate where the T-connectors will be used. Such a design will help you to determine how to cut the soft pipe and prevent wastes.

(Water bucket need to be placed lower than pump in case siphonage effect which is dirt track back into clean water)

2. Outlet Pipe

Measure the distance between your plant pot to the watering device, and tailor the pipe into that length. Insert dripper to one end of the tube. Install the outlet pipe with dripper to the pump.

3. Inlet Pipe

Measure the distance between the water source and the device, and tailor the pipe into that length. Insert filter to one end of the pipe. Install inlet pipe with its filter to the pump.

4. Power Supply

Insert 4 AA batteries to the power slot

or connect the 5V USB cable to the power port.

Water Timer Setting

1. Wake Up Press any button to wake up the indoor drip irrigation kit 2. WATERING Time Press the Middle Button, the "WATERING TIME" blinks 3. Time & Unit Long press the up or down button until it jumps to the desired unit and number 4. Watering Interval Press the middle button to save it and go to the watering frequency settings, the "Watering Interval" blinks 5. Time & Unit Long press the up or down button until it jumps to the desired unit and number 6. Delay Press the middle button to save it and go to the delay setting, the "Delay" blinks 7. Time & Unit Long press the up or down button until it jumps to the desired unit and number 8. Save Press the middle button to save and finish setting

Q&A Troubleshoot

1) Why it's watering weakly or water overdosing? Please check:

1. Avoid Siphon. Water source /water bucket /water surface level should not be placed higher than the pump. 2. Because of the high power pump, we suggest set up more than 4 drippers, the more drippers you set up the longer life of the pump. 3. If you set up more than 4 drippers, please don't set up with the cross joint (4-way joint). 4. Please check the filter, we suggest clean the filter each week. 5. Please adjust inlet pipe should not over than 9.8ft, 3.2~6.5ft is the best length. 6. The plants should not higher than 6.5ft (vs the water source). 7. Please adjust outlet pipe should not over than 33ft. 8. Please check the drippers is well connected with the pipe, if not it will to be leaking. 9. When finish the set up, you'd better soak the tube in the hot water (which part is connected with the drippers) to make the pipe and the dripper much compact.

2) Why it's not working? Please check if these were well set:

1. No bending or No clogging inside the tube. 2. Please check battery. The pump waters weakly when battery's electricity volume is low. If you only use AA battery, you'd better choose alkaline battery, we suggest connect to USB power supply for frequent use. 3. Timer was set correctly. [First to set watering time, second to set the interval time, third to press the middle button to confirm] 4. Refer to our digital PDF manual as below for more. [Please login on your PC to find it]

3) The water flow of the drip emitter:

Because the drip emitter is voltage regulator design, it can provide the relatevely steady flow for your plants when it is correct setting; This way it can make sure each drip emitter is working and easy to control; Because of the high power pump, we suggest to connect more than 4 drip emitters; The reference average flow rate there are: 4 drippers, 60~80ml/min; 6 drippers, 60~70ml/min; 8 drippers, 50~70ml/min; 10 drippers, 40~60ml/min; 12 drippers 30~50ml/min; 15 drippers, 30~40ml/min; For example, when you setting on 4 drippers, the water flow of each drippers is about 60~80ml/min; You can according to the reference average flow rate to increase or decrease drippers for your plants; If you find some drip emitters are abnormal flow, you need to replace the hose or the drippers;

Package Dimensions ‏ : ‎ 8.7 x 6.73 x 3.7 inches; 1.7 Pounds
Item model number ‏ : ‎ SPLANT-LCD-15-white
Date First Available ‏ : ‎ June 15, 2022
Manufacturer ‏ : ‎ sPlant
ASIN ‏ : ‎ B0B463JN86

🌷【Italian Patent Design & Simplified Program】Patent minimalist industrial design from Italy team, always a classic look to your home. New version automatic watering system device is equipped with large LCD module, the display is clear and soft. Replace indicator light with flashing graphics, device status is easy to read. Redefine the setting logic, just by press the up and down button user can easily adjust the value and switch the unit, and then confirm the setting with the set button;
🌷【Pump Upgrade & Two Power Methods】High-power drip irrigation pump, power upgrade 5 times. Solve water pressure problems, strong water supply. Two type of power supply, 4 AA batteries (NOT Included) and USB cable charging;
🌷【Controllable Watering Time and Frequency】The smart sprinkler can water once an hour to once 30 days. And watering 5 seconds to 59 minutes. User can control the watering time and frequency according to their needs. Free your hands to water your indoor plants with no worries of vacations, busy schedules, or weather changing;
🌷【Provide Steady Flow and Deep Irrigation】Because the drip emitter is voltage regulator design, it can provide the relatively steady flow for your plants when it is correct setting; This way it can make sure each drip emitter is working, and you can increase or decrease the count of drip emitters to control the water flow;
🌷【Easy to DIY】 A roll of 33ft pipe is provided, which can be cut to the desired length as required. T joints connect water sources and plants by connecting water pipes to achieve simultaneous irrigation. The automatic drip irrigation system kit can irrigate 15 pots of houseplants at the same time;
🌷【WATER-SAVING DESIGN】Use 70% less water than traditional spray & drip heads, by spot watering only exactly where needed, making your drip system great for saving water in drought conditions. 【There’s a update digital PDF manual (202202) for downloading and your convenience.】